Skip to main content

New page of erosion articles

EPA Targets Construction-Site Pollution
WASHINGTON - The Environmental Protection Agency issued a final rule Monday aimed at reducing pollution from construction sites, saying that it will significantly improve the quality of water nationwide.
The rule will be phased in over four years, starting in February, and when it is fully in effect, the EPA estimates there will be four billion fewer pounds of sediment discharged from construction sites each year.

Visit your newest erosion article page to read this and many more

Comments

Popular posts from this blog

Erosion Control, and Nanotechnologies (NT)

Erosion Control Forum – Information on erosion control devices and resources Skip to content Abstract Nanotechnology (NT) The National Nanotechnology Initiative defines nanotechnology as understanding and controlling matter at dimensions between approximately 1 and 100 nanometers, where unique phenomena enable novel applications. Introduction Nanotechnology offers the potential to effectively treat contaminants in situ, avoiding excavation or the need to pump contaminated water out of the ground. The process begins with nanoparticles being injected into a contaminated aquifer via an injection well. Role of Nanotechnology Nanotechnology plays a crucial role in improving wind turbine performance...

Environmental Issues

Erosion Control Forum – Information on erosion control devices and resources Skip to content Bioventing Description Bioventing is an in situ remediation technology that uses microorganisms to biodegrade organic constituents adsorbed on soils in the unsaturated zone. Bioventing enhances the activity of indigenous bacteria and simulates the natural in situ biodegradation of hydrocarbons in soil by inducing air or oxygen flow into the unsaturated zone and, if necessary, by adding nutrients. During bioventing, oxygen may be supplied through direct air injection into residual contamination in soil. Bioventing primarily assists in the degradation of adsorbed fuel residuals, but also assists in the degradation of volatile organic compounds (VOCs) as vapors move slowly through biologically active...

Geogrid

Erosion Control Forum – Information on erosion control devices and resources Skip to content A geogrid is geosynthetic material used to reinforce soils and similar materials. Soils pull apart under tension. Compared to soil, geogrids are strong in tension. This fact allows them to transfer forces to a larger area of soil than would otherwise be the case.[citation needed]. Geogrids are commonly made of polymer materials, such as polyester, polyvinyl alcohol, polyethylene or polypropylene. They may be woven or knitted from yarns, heat-welded from strips of material, or produced by punching a regular pattern of holes in sheets of material, then stretched into a grid.Geogrid is typically used for soil reinforcement applications such as retaining walls, steepened slopes, embankments, sub-grade stabilization, embankments over soft ...