Skip to main content

Fluvial Processes

Fluvial Processes

Sediments are most often transported by water (fluvial processes), wind processes) and glaciers. Beach sands and river channel deposits are examples of fluvial transport and deposition, though sediment also often settles out of slow-moving or standing water in lakes and oceans. Desert sand dunes and loess are examples of aeolian transport and deposition. Glacial moraine deposits and till are ice-transported sediments
A grim reminder of the widespread result(s) of sediment is exacerbated with the all-too-common warning of resulting and uncontrolled erosion.
A survey on the sources of sediment pollution resulted in the warning for citizens not to harvest vegetables grown on artificial wetlands.

We must take steps to mitigate erosion

Comments

Unknown said…
Prevention is better than cure as they say. A good soil and water management plan is necessary in order to prevent damage caused by suspended solids from water. Some Geotechnical Site Investigation services carry out Erosion and Sediment assessment in order to identify potential erosion problems and make necessary recommendations to prevent it.
October 30, 2014 at 12:42 AM
Post a Comment

Popular posts from this blog

Erosion Control, and Nanotechnologies (NT)

Erosion Control Forum – Information on erosion control devices and resources Skip to content Abstract Nanotechnology (NT) The National Nanotechnology Initiative defines nanotechnology as understanding and controlling matter at dimensions between approximately 1 and 100 nanometers, where unique phenomena enable novel applications. Introduction Nanotechnology offers the potential to effectively treat contaminants in situ, avoiding excavation or the need to pump contaminated water out of the ground. The process begins with nanoparticles being injected into a contaminated aquifer via an injection well. Role of Nanotechnology Nanotechnology plays a crucial role in improving wind turbine performance...
2 comments
Read more

Environmental Issues

Erosion Control Forum – Information on erosion control devices and resources Skip to content Bioventing Description Bioventing is an in situ remediation technology that uses microorganisms to biodegrade organic constituents adsorbed on soils in the unsaturated zone. Bioventing enhances the activity of indigenous bacteria and simulates the natural in situ biodegradation of hydrocarbons in soil by inducing air or oxygen flow into the unsaturated zone and, if necessary, by adding nutrients. During bioventing, oxygen may be supplied through direct air injection into residual contamination in soil. Bioventing primarily assists in the degradation of adsorbed fuel residuals, but also assists in the degradation of volatile organic compounds (VOCs) as vapors move slowly through biologically active...
1 comment
Read more

Geogrid

Erosion Control Forum – Information on erosion control devices and resources Skip to content A geogrid is geosynthetic material used to reinforce soils and similar materials. Soils pull apart under tension. Compared to soil, geogrids are strong in tension. This fact allows them to transfer forces to a larger area of soil than would otherwise be the case.[citation needed]. Geogrids are commonly made of polymer materials, such as polyester, polyvinyl alcohol, polyethylene or polypropylene. They may be woven or knitted from yarns, heat-welded from strips of material, or produced by punching a regular pattern of holes in sheets of material, then stretched into a grid.Geogrid is typically used for soil reinforcement applications such as retaining walls, steepened slopes, embankments, sub-grade stabilization, embankments over soft ...
Post a Comment
Read more